Lapping disc, grit 1000, non-adhesive, Ø240 mm
It is recommended to "break in" a new disc using a brass block to properly condition the abrasive surface.
Apply tallow to prevent heat transfer and achieve a perfect lapping finish.
Installation : Apply spray adhesive in a very thin layer from approximately 30 cm, then place the disc onto the machine.
Made in Germany
Lapping disc, grit 1000, non-adhesive, Ø240 mm
It is recommended to "break in" a new disc using a brass block to properly condition the abrasive surface.
Apply tallow to prevent heat transfer and achieve a perfect lapping finish.
Installation : Apply spray adhesive in a very thin layer from approximately 30 cm, then place the disc onto the machine.
Made in Germany
check_circle
check_circle
.png)
.png)
.png)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent