Protective lacquer for steel parts, watch bracelets and watch cases during machining, polishing, satin finishing, laser marking or welding operations.
Instructions for use :
• Spray the surface to be protected from a distance of approximately 10 to 20 cm
• Allow to dry for 5 to 10 minutes depending on the thickness of the applied layer
• After use, turn the can upside down and press the valve until only gas is released
• Pressurized container - Do not spray onto an open flame or incandescent material - Do not pierce or burn, even after use
• The lacquer can be removed using Galvex 20.02
Made in Switzerland
.png)
.png)
.png)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent